Kitty Love with a Wobble!

I think this cutie kitty card is going to be for my daugther.  The cat was cut using Create a Critter at 3".  I decided to use fun flock and make her furry.   If you're new to fun flock, there are a couple of tips:

1.  run the item through your Xyron upside down to get an even sticky surface.

2.  Once you're run it through, if you have the larger Xyrons, like I do, you should take your glue remover (this is an uneven surface rubber eraser like item) and remove glue in places you don't want it.   For example, I rubbed it over the cuts for the whiskers, over her eyes, mouth and ears to get rid of excess glue that I don't want to fight with once I add flock.

3. Pour the flock onto your item, over top of a piece of paper so that you can pour the excess flock back into the container.  Once you have the entire item generously covered with flock, use your finger to press the flock into the surface of the item.  Then rub off excess.

  I decided not to use the Cricut nose for her and instead used a heart brad.   Then, I used cotton candy stickles on the inside of her ears and black diamond stickles on her whiskers.   I also used stickles on her bow and added a big 'diamond'gem. 

So, I made the kitty wobble as well which was a first for me.   I have seen the action wobbles but, I decided to try to make them myself so, I bought some 26 gauge copper jewelry wire for less than $3 and cut about a 2" piece.   I wrapped it around my finger and then taped it to the card and the other side to the kitty.   It worked perfectly.   NOTE:   My first instinct was to make a larger wobble but, it doesn't work well, it only allows your item to wobble all over the place versus wobbling in the spot you want.   Next time I do one, I will take a picture of the wobble inside as well, sorry I didn't think of that until now!

So, when I went to cut the pillow, accessory, I assumed I should cut at 3".  It was huge.   So, I re-cut it at 1 1/4".   I ran it through the Cuttlebug using Swiss Dots and then added the 'fringe' ribbon on the bottom.  The stamp sentiment is from a G Studio mini set that I picked up for $.49 on clearance.   I stamped it on the pink scallop that I cut using the Preserves cartridge, the Apple4, lid cut at 1 1/2".

The mat aqua paper has xo's on it and is from the DCWV Madly in Love stack.  Then, I cut the scallop cut, also using Preserves.   The cut was the card cut on the Plum2.   I had to cut it using DS though because I needed the cut to be 5 1/4 x 4" and I used the DCWV Christmas Glitter stack for it, in white.

The inside, I cut the mat on white cardstock by going into the DS frame about and just hiding the inside cut of the frame.  I inked the edges in pink and then stamped the sentiment and the little paw prints in the same pink.  Have a great day everyone!

Angie